[Apr 11, 2024] Lesson Brilliant PDF for the NSE7_SDW-7.0 Tests Free Updated Today
Get New 2024 Valid Practice NSE 7 Network Security Architect NSE7_SDW-7.0 Q&A - Testing Engine
NEW QUESTION # 23
Refer to the exhibits.
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
- A. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- B. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
- C. London generates an IKE information message that contains the Toronto public IP address.
- D. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
Answer: B,D
NEW QUESTION # 24
Refer to the exhibit.
Based on the exhibit, which action does FortiGate take?
- A. FortiGate brings up port5 after it detects all SD-WAN members as alive.
- B. FortiGate bounces port5 after it detects all SD-WAN members as dead.
- C. FortiGate brings down port5 after it detects all SD-WAN members as dead.
- D. FortiGate fails over to the secondary device after it detects all SD-WAN members as dead.
Answer: D
NEW QUESTION # 25
Refer to the exhibit.
Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)
- A. After FortiGate switches to active mode, FortiGate never fails back to passive monitoring.
- B. FortiGate can offload the traffic that is subject to passive monitoring to hardware.
- C. During passive monitoring, FortiGate can't detect dead members.
- D. FortiGate passively monitors the member if TCP traffic is passing through the member.
Answer: C,D
NEW QUESTION # 26
Refer to the exhibit.
Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)
- A. The number of simultaneous connections allowed for each source IP address cannot exceed five connections.
- B. The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.
- C. The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.
- D. The number of simultaneous connections among all source IP addresses cannot exceed five connections.
Answer: A,C
NEW QUESTION # 27
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. The FortiGate cloud key has not been added to the FortiGate cloud portal.
- B. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- C. A factory reset performed on FortiGate.
- D. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- E. The zero-touch provisioning process has completed internally, behind FortiGate.
Answer: A,E
NEW QUESTION # 28
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)
- A. http
- B. icmp
- C. twamp
- D. dns
Answer: A,D
Explanation:
Pages 85,86 in Study guide 7.0 Pages 100,101 in Study guide 7
NEW QUESTION # 29
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
- A. You can reference meta fields.
- B. You can configure advanced CLI settings.
- C. You can configure interfaces as SD-WAN members without having to remove references first.
- D. You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.
Answer: A,B
NEW QUESTION # 30
What is a benefit of using application steering in SD-WAN?
- A. The traffic always skips the regular policy routes.
- B. You do not need to configure firewall policies that accept the SD-WAN traffic.
- C. You do not need to enable SSL inspection.
- D. You steer traffic based on the detected application.
Answer: D
NEW QUESTION # 31
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows the SD-WAN performance SLA configuration, the SD-WAN rule configuration, and the application IDs of Facebook and YouTube. Exhibit B shows the firewall policy configuration and the underlay zone status.
Based on the exhibits, which two statements are correct about the health and performance of port1 and port2? (Choose two.)
- A. FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.
- B. FortiGate is unable to measure jitter and packet loss on Facebook and YouTube traffic.
- C. The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.
- D. Non-TCP Facebook and YouTube traffic are not used for performance measurement.
Answer: C,D
Explanation:
Study Guide 7.0, pages 88 - 89.
Study Guide 7.2, pages 103 - 104.
Another comment said "because without using application Control on the firewall policy, SDWAN can't work" but there is a app control "default" defined on config.
NEW QUESTION # 32
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?
- A. Destination internet service must be enabled on the traffic shaping policy.
- B. Application control must be enabled on the firewall policy.
- C. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.
- D. Web filtering must be enabled on the firewall policy.
Answer: B
NEW QUESTION # 33
Refer to the exhibits.
Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)
- A. The measured bandwidth is less than 100 KBps.
- B. The traffic shaper drops packets if the bandwidth is less than 2500 KBps.
- C. The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.
- D. The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.
Answer: A,D
NEW QUESTION # 34
Which SD-WAN setting enables FortiGate to delay the recovery of ADVPN shortcuts?
- A. hold-down-time
- B. idle-timeout
- C. auto-discovery-shortcuts
- D. link-down-failover
Answer: A
NEW QUESTION # 35
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set priority 10.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set cost 15.
Answer: A,D
NEW QUESTION # 36
Refer to the exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.
- B. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.
- C. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
- D. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
Answer: D
NEW QUESTION # 37
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose two.)
- A. FortiGate always blocks all traffic, after a route change.
- B. FortiGate flushes all routing information from the session table, after a route change.
- C. FortiGate does not change the routing information on existing sessions that use a valid gateway, after a route change.
- D. FortiGate performs routing lookups for new sessions only, after a route change.
Answer: C,D
NEW QUESTION # 38
Refer to the exhibit.
Which statement about the role of the ADVPN device in handling traffic is true?
- A. This is a spoke that has received a query from a remote hub and has forwarded the response to its hub.
- B. Two hubs, 10.0.1.101 and 10.0.2.101, are receiving and forwarding queries between each other.
- C. Two spokes, 192.2.0.1 and 10.0.2.101, forward their queries to their hubs.
- D. This is a hub that has received a query from a spoke and has forwarded it to another spoke.
Answer: D
NEW QUESTION # 39
What are two benefits of using the Internet service database (ISDB) in an SD-WAN rule? (Choose two.)
- A. The ISDB requires application control to maintain signatures and perform load balancing.
- B. The ISDB applies rules to traffic from specific sources, based on application type.
- C. The ISDB contains the IP addresses and port ranges of well-known internet services.
- D. The ISDB is dynamically updated and reduces administrative overhead.
Answer: C,D
NEW QUESTION # 40
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change?
(Choose two.)
- A. FortiGate terminates the old sessions.
- B. FortiGate does not change existing sessions.
- C. FortiGate flushes all sessions.
- D. FortiGate evaluates new sessions.
Answer: B,D
Explanation:
Explanation
FortiGate not to flag existing impacted session as dirty by setting firewall-session-dirty to check new. The results is that FortiGate evaluates only new session against the new firewall policy.
NEW QUESTION # 41
Refer to the exhibit.
The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured packet loss will make T_INET_1_0 the new preferred member?
- A. When T_INET_1_0 has 4% packet loss.
- B. When all three members have the same packet loss.
- C. When T_INET_0_0 has 12% packet loss.
- D. When T_INET_0_0 has 4% packet loss.
Answer: B
NEW QUESTION # 42
Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?
- A. get router info routing-table all
- B. diagnose debug application ike
- C. get ipsec tunnel list
- D. diagnose vpn tunnel list
Answer: B
NEW QUESTION # 43
......
Fortinet NSE7_SDW-7.0 exam covers a variety of topics related to SD-WAN technology, including SD-WAN architecture, deployment scenarios, and configuration options using Fortinet's SD-WAN products. NSE7_SDW-7.0 exam also covers key security concepts such as encryption, authentication, and access control, as they relate to SD-WAN solutions.
Fortinet NSE7_SDW-7.0 exam is a comprehensive and challenging certification program that tests the candidate's knowledge and skills in deploying, configuring and managing Fortinet's SD-WAN solutions. It is an essential certification for IT professionals who want to demonstrate their expertise in this increasingly important area of networking technology.
NSE7_SDW-7.0 Dumps PDF - 100% Passing Guarantee: https://www.actualpdf.com/NSE7_SDW-7.0_exam-dumps.html
Latest NSE7_SDW-7.0 PDF Dumps & Real Tests Free Updated Today: https://drive.google.com/open?id=1n1fQ0wHGo9pmDBGjMaBZrshPArkPB5br
