[Jan-2022] Exam DES-DD33: New Brain Dump Professional - ActualPDF
Free DES-DD33 Exam Dumps to Improve Exam Score
EMC DES-DD33 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
NEW QUESTION 14
When using the DD VTL Tape Out to Cloud feature, which status will a tape show once it is in the cloud tier vault?
- A. Vaulted
- B. Offline
- C. Offsite
- D. Archived
Answer: D
NEW QUESTION 15
Where can daily information on system and MTree capacity be found?
- A. DDSM Health Overview
- B. Message log
- C. Autosupport report
- D. Support Bundle
Answer: C
NEW QUESTION 16
Where is the DD System Manager can the status of chassis components be found?
- A. Health > Chassis
- B. Hardware > Chassis
- C. Maintenance > Chassis
- D. Home > Chassis
Answer: B
NEW QUESTION 17
What is the correct sequence of steps to configure storage for Dell EMC Cloud Tier in the DD System Manager?
Answer:
Explanation:
NEW QUESTION 18
What is a characteristic of using replication with Dell EMC Cloud Tier?
- A. Always takes place between the source and destination cloud tier
- B. Does not require that a file be recalled from the cloud on the source
- C. Always takes place between the source and destination active tier
- D. Cloud Tier is required to be configured on the source and destination systems
Answer: C
NEW QUESTION 19
A Spectrum Protect administrator is configuring VTL on PowerProtect DD.
Which tape driver type should they select?
- A. L2000
- B. L6000
- C. TS3500
- D. L180
Answer: C
NEW QUESTION 20
Backup administrators have noticed slow backups on the AIX environment.
To fix the issue, what should the set large_send be for each NIC, and what should the NFS option be set to?
- A. no and nfs_rfc1323=0
- B. yes and nfs_rfc1323=0
- C. no and nfs_rfc1323=1
- D. yes and nfs_rfc1323=1
Answer: D
NEW QUESTION 21
Which PowerProtect DD procedure uses the DoD/NIST standards to provide data security?
- A. Replication Encryption
- B. Data Sanitization
- C. Encryption
- D. End-to-End Verification
Answer: B
NEW QUESTION 22
An administrator has retained snapshots for a single MTree and is trying to create a new one. An error message is received.
What is the reason for the failure?
- A. The user does not have the permission to retain more snapshots
- B. The DDOS needs to be upgraded
- C. There are not enough snapshot licenses
- D. The maximum number of snapshots has been exceeded
Answer: D
Explanation:
Note: To identify an MTree that is nearing the maximum number of snapshots, check the Snapshots panel of the MTree page regarding viewing MTree snapshot information.
NEW QUESTION 23
An administrator is migrating their old cloud tier-enabled Data Domain to a new PowerProtect DD appliance with cloud tier. During migration, the administrator recognizes that file system cleaning on the source system is not possible.
What is the most likely cause of this behavior?
- A. Migration will restrict all activities on source system
- B. Source system is running in restricted mode
- C. Migration will restrict all activities on both systems
- D. Filesystem is disabled on source system
Answer: A
NEW QUESTION 24
Which protocol is used for communications between a PowerProtect DD appliance and cloud tier to Dell EMC ECS?
- A. FTP
- B. HTTP
- C. SSH
- D. SSL
Answer: B
NEW QUESTION 25
An administrator wants to integrate a PowerProtect DD appliance into their current backup environment using CIFS, NFS, DD Boost, and VTL.
Which backup applications support these protocols?
- A. Veritas NetBackup and Dell EMC NetWorker
- B. Commvault Simpana and Veritas Backup Exec
- C. IBM Spectrum Protect and Veritas NetBackup
- D. Dell EMC Avamar and Dell EMC NetWorker
Answer: A
NEW QUESTION 26
A PowerProtect DD appliance has been installed at a company's location for several months and has reached a steady state.
As a best practice, at what percentage of disk utilization should action be taken?
- A. 80%
- B. 60%
- C. 70%
- D. 95%
Answer: A
NEW QUESTION 27
A storage administrator finished the zoning between the PowerProtect DD and the NetWorker backup server.
How can they verify that the zoning was completed properly and the server HBA are visible?
- A. scsitarget show initiator list
- B. scsitarget show initiator
- C. scsitarget initiator show list
- D. scsitarget initiator list
Answer: C
NEW QUESTION 28
How many hops should the fabric configuration be limited to when implementing the DD VTL?
- A. 1 hop
- B. 2 hops
- C. 4 hops
- D. 3 hops
Answer: B
NEW QUESTION 29
A customer needs a backup system to protect 100 TB of mission-critical data.
What should be used to back up the system?
- A. cloud tier
- B. DD3300
- C. DDVE
- D. DD6900
Answer: A
NEW QUESTION 30
An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high.
What is the most likely cause of this behavior?
- A. Disk failure
- B. Known segments
- C. NVRAM failure
- D. Expired segments
Answer: B
NEW QUESTION 31
What is a main advantage of using DD Boost instead of CIFS or NFS for a backup?
- A. No requirement for an IP network to back up data
- B. DD Boost does not require administration credentials
- C. DD Boost uses integrated network acceleration
- D. Deduplication is distributed between the backup server and client
Answer: D
Explanation:
Dell EMC Data Domain Boost software distributes parts of the deduplication process to the backup server(s) or application client(s), leaving the Data Domain system, powered by Intel® Xeon® processors, to focus its energy on determining what is unique and writing the new data to disk. With DD Boost, only the unique data has to travel from the backup server or client to the Data Domain system. DD Boost also gives the backup application control over replication
NEW QUESTION 32
An organization uses tape libraries in their current backup infrastructure. They have purchased a PowerProtect DD system and plan to use VTL to move from physical tape.
What is a consideration when configuring the tape size?
- A. Set retention periods for as long as possible
- B. Use multiple drives to write multiple streams
- C. Use larger tapes for multiple smaller datasets
- D. Target multiple drives to write single stream
Answer: B
NEW QUESTION 33
How many hops should the fabric configuration be limited to when implementing the DD VTL?
- A. 1 hop
- B. 2 hops
- C. 4 hops
- D. 3 hops
Answer: B
Explanation:
Maximum number of hops is two, that is, three DD systems. Directory-to-MTree migration supports backward compatibility up to two previous releases.
NEW QUESTION 34
What is a requirement to use the PowerProtect DD HA feature?
- A. Head units and notes require an active/active configuration
- B. Dual set of shared storage configuration
- C. Each head unit requires its own FS25 shelf
- D. A single set of shared storage
Answer: B
NEW QUESTION 35
When should using Virtual Synthetic backups be considered?
- A. Backups are nonfile system data such as databases
- B. Daily incremental backups are larger than 15% of a normal full backup
- C. PowerProtect DD appliance has more than 10 disks
- D. Backups are large and localized
Answer: B
NEW QUESTION 36
......
Powerful DES-DD33 PDF Dumps for DES-DD33 Questions: https://www.actualpdf.com/DES-DD33_exam-dumps.html
